handheld_addict, Nov 10, 2014 : Bought from eBay, $2.66USD: http://www.ebay.ca/itm/400755784339...eName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649 I just received this today... took about 16 days to ship to Canada. Your basic tpu case, glossy/grippy along the sides, frosted matte finish on the back. I was hoping that I could still see the 1+, but only the Cyanogen shows through. I really wanted a soft thin case that protects from falls and raises above the screen a bit if the OPO is laying face down. The bezel around the screen isn't very high, and I don't think this case would keep the screen off a surface laying face down. The cutouts are ok, the back microphone hole is not centered but it isn't covered. There is a little bit of excess plastic around the right speaker, not a huge deal, just a general fit & finish kind of thing. The usb port is accessible, but the case needs to bend around most plugs. Cutouts for the volume rocker and power button. The headphone jack cutout seems a little small. I use slim plug earbuds that won't have any trouble, but some plugs might be a bit tight for that size cutout. Overall, a nice tpu case, but there is a bit of a sharp feeling around the border of the case, where the top part of the plastic was bonded the bottom part. I might try to take an x-acto knife to trim the excess plastic flashing off.